Interested to Buy Any Domain ? << Click Here >> for more details...
If single phase supply is 220v. then why three phase supply is 660?
- 2 Answers
- 5007 Views
- I also Faced
- E-Mail Answers
Answer Posted / sumit kumar jha
no because one earthing is also present ..so 220v or 440v is perfect answer...same case two earthing also used in 3 phase supply but mainly one taking all times...
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
what's the difference between abs/inc encoders. apart from the position remembrance what are all the other differences. and what's mean by grey code.
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
why the active power flow of some line is increased when the active power of out is cut ?
State thevenin’s theorem?
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
Define maximum demand?
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
Please tell me in DETAIL about the following 3 types of fuses or recommend me a good power system protection book or a website link ? 1.Dropout Fuse 2.Striker Fuse 3.Empulsive fuse (not sure if its impulsive or explosion fuse , sorry)
design of IGBT firing circuit for 11KV
What is a system?
how can maintaince the acb contactor moveing and fixing kit
What is the effect of positive feedback on stability of the system?
How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.
What is phase cross over frequency?
