Interested to Buy Any Domain ? << Click Here >> for more details...
Wht should be the ratio of natural frequency (Fn) to wake
frequency (Fw) and wht if goes above the rato limit?
- 2 Answers
- 7503 Views
- I also Faced
- E-Mail Answers
Answer Posted / jigar anadkat
As per latest revised standard the ratio should be 0.4 (ASTME 19.3:2010)
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
What is the difference between uv and ir scanners? and what is the workig principle of both
What is heating effect?
State bernoulli’s application.
how to calibrate load cell
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
Name different parts of a pressure gauge.
what is the difference between magnetic flow meter and mass flowmeter
key phaser where is use and work
Isometric drawings are generated during _________________ phase of a project
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
Calibration procedure for water rotameters
How d.p. Transmitter can be applied to close tank?
what is the protection system in solar turbine compressor
