Interested to Buy Any Domain ? << Click Here >> for more details...
what is OLTC and difference between RTCC and OLTC
- 7 Answers
- 34715 Views
- Sodexo, I also Faced
- E-Mail Answers
Answer Posted / rakesh sharma
OLTC means on load tap changer & RTCC means remote tap changing control.OLTC change the tap according to voltage variation & oltc get signal from rtcc, according to voltage variation it increase or decrease the tap.RTCC get signal from HT panel.If HT voltage high or low RTCC give signal to OLTC to increase or decrease the voltage.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
WHAT IS MEANT BY OVER EXCITATION IN GENERATOR TRANSFORMERS? DESCRIBE IT.
What current flows in the transformer primary when its secondary is open?
What the main causes of transient interruptions on Over-Head Distribution Lines?
66kv under ground cable how to layaing in ground any special case two ckt r runing
circuit diagram of trip circuit supervision relay
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
The inventer is a battery, but if lost current at home u will turn on the fan but the is AC and inventer battery is dc . Then how the fan was rotating. What device Or machine in fan converst the Dc power to Ac power
reason of diode failure in alternator
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
WHAT IS FAULT CAPACITY OF HT MOTOR TERMINAL BLOCK? ANY BODY HAVE ANSWER PLZ....POST IT.
what is the function of capacitor duty contactor in an capacitor panel???
What is PQA???Applications........
how can decide the current rating of oltc
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
