Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference b/w wet leg & dry leg level method
- 2 Answers
- 7417 Views
- I also Faced
- E-Mail Answers
Answer Posted / naveed iqbal butt
wet leg,we use there spcific gravity not constant in the
close tank,also we use seal pot filled with silicone
oil.and dry leg we use there spcific gravity constant in
the close tank.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
how we are selecting instuments by differentiating certain instruments in 4 to 20 ma range and certain in 1 to 5 v dc
what is instrument philosophy
What is Predictive Maintenance
please send data bank of quetions answers on analytical instrumentation.
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
Identification of ss fittings, pilot valves, relief valve.
why we r opening HOT BYPASS valve during startup of a compressor?
how u calibrate pneumatic n motorized c/v?
what is function of sensor, and how is it work , explain with difination
typical loop drawing of a simple feedback control comprising of one transmitter and one control
How to calibration a control valve?
What are the application of bernoulli’s theorem?
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
