what is the abbreviation & meaning of UI charges
- 1 Answers
- 7255 Views
- MNC, I also Faced
- E-Mail Answers
Answer Posted / nagarajan
Un scheduled Interchange charges. This charges is being
collected by Regional Load Despatch Centre based on frequency
which is called ABT(Availability Based Tariff)Regulated by
CERC (Central Electricity Regulatory Commission)
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
how to carried out tan delta test in 11 KV alternator ?
how much GROUND & NEUTRAL VOLT maintain in data center.
what is difference between isolation and ultra isolation transformer?, what is the method of testing ?
List examples of voltage source?
What is acsr cable and where we use it?
What are PLC leader logic program method
Earth bits close or open. Which is correct
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
How will you justify IR value and Charging voltage of any motor,transformer and Cables.......???? . . . . . . . . Plz tell me any body Baljeet Singh, engineer_89@refiff.com
in non technical way how can u define POWER FACTOR??
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
What is the one main difference between ups & inverter ? And electrical engineering & electronics engineering ?
What are the components of feedback control system?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
