suppose we using 3 phase motor of 440 v means what range of
C.T. is require for measuring current , the rating of motor
is 1HP ?
Answer Posted / simon
1 HP=735.5W
735.5W=440V*1.67Amp
So no need of C.T U can use only AMETER.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
can anyone please help me to find the rupturing or breaking capacity in KA of circuit breaker (MCCB,VCB,ACB etc) of HT and LT side of a distribution transformer...please help with detailed step by step answer...thank you
Define ohm’s law for a.c (alternating current)?
why they were using TRIAC instead relay in some controllers and what is the advantages.
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
What kind of maintenance is conducted for Transformer
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
how many electricity poles are there and what are the names and their sizes.
how to carried out DAR test in 11 KV Alternator ?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
What are dcs and plc?
can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?
What the difference between ac and dc inductor an capacitor