Interested to Buy Any Domain ? << Click Here >> for more details...
How many electrones need to flow in one second to
equivalent to one Ampere.
- 3 Answers
- 6108 Views
- I also Faced
- E-Mail Answers
Answer Posted / simon
6.28*10 to the power 18/ amp
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
single phase power supply give to separate one steel coup with water, what reaction create
WHY IS THE EARTH FAULT CURRENT ALWAYS LESS THAN THE NORMAL CURRENT??
what will happen when the dc supply is given to the capacitor?
What is nichols chart?
how to flameproof electrical motor on the shaft?
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
Explain cos(theta) and Sin(theta)
what is upper impedance and lower impedance of a distance relay
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .
what is the maximim current drawn by 1 phase and three phase welding machine
While testing a ZCT what parameters have to check or measure?
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
