Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference b/w chock and ballast?
- 2 Answers
- 4997 Views
- Emami, I also Faced
- E-Mail Answers
Answer Posted / simon
1.Choke is a type of x-mer which step down's 250v a.c in to 110v a.c.
2.Blast is a electronic circuit which converts 250v a.c into 110v pure d.c.This effect produces a rapid & continuous flow of electricicy.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How to test REF relay testing for LV panel as per Kahramaa standard?
how test transfomer(3 phase75kva) by megger
what is the difference between earthing and unearth
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
do you have some of interview Questions in power and genrator section in general whith answers
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
defination of controlled shunt reactor
Why ground terminal is used in pot meter 10k ohms
WHY BLADE & JOW OF ISOLETOR IN SUBSTATION?
What is resonant frequency?
we use 400/5A ct and 35/roor3KV,/0.1/root3KV,0.1/root3KV pt ratio. What is the multiple factor of this meter.
What are the causes for the failures of sandwich type (Al) busducts?
when ac current flows thru d coil of a contactr,it energizes,magnetic field attracts d contact of the coil...nw wont dt ac current in d contct induce current back on to d coil thru mutual inductance leading to high currnt in d coil
what is the criteria for selecting fuse rating in 1phase, 2phase & 3phase welding sets?
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
