Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sandeep.sekharan@yahoo.com
Heat absorption is the main extinguishing property of FM 200 system and oxygen replacement is secondary.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Define settling time.
sir i have cleared the apti test of EIL held on 15th march and my interview will be in new delhi on 2nd june.i will be very much helpful if u help me regarding the type of interview questions comes at EIL.(URGENT.........PLZZZZZZZZZZ...............)
Draw a SLD of DG distribution up to main LT panel?
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
volts=230 c=10mf a=??
how to decide the panel size like MDB ,SMDB PANEL SIZES
what is the use of the puls transformer in UPS & how it works???????????
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
If SFU is Switch Fuse Unit, What is the expansion for FSHF in Electrical Engineering?
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
How do we calculate over and under frequency tolerance from generator data?
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
oltc of a transformer, how it works? and what are the equipment consist of describe briefly?
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
