Answer Posted / nodoginthishunt
Read the debate about ABB's PPA HMI here:
http://www.control.com/thread/1026243614
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
How d.p. Transmitter can be applied to close tank?
how to calculate control valve bonnet size?? or how to select its material?
on interface level transmitter model(RTG3302-EMERSON) What is threshold valve how can we select correct threshold value T1,T2,T3,T4 When interface water & hydro carbon
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
Why plc require in analog input 4-20amp & 0-10 volt?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..
What is the use of double seated valve?
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
KAlman filter code for two dimension?
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
pls give me presant awerness quistion and answer in my emailid.
