what is the function of short circuit maintenance ct and
droop ct.
Answer Posted / kj
These are both used on a DG.
The short circuit maintenance CT is used to keep the output
voltage and current high enough to clear a fault by
tripping an overcurrent device (circuit breaker).
The droop CT is used to cause the voltage to decrease as
the kvar load rises. This is used to help DG's share the
kvar load.
Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?
What is mean by Sensitive Earth fault & what are the effects
in my industry we are using 3 step up transformers for induction heaters..i.e 415/580v and other are 11/440v.in power consumption does a step trnsformer makes any difference compared to step up?? plz explain
WHat is the general checks required for Dry type transformers
wat is meant by PX class in ct?
11 kV line deraction check by an Engineer.
what is the size of cable for 15kw motor and 85 meter cable length using with vfd
write a program that prints prime numbers from 1-20 in digonal form
how to electrically make connection to ferroli GN2N?
What is the estimated total hydropower potential of india?
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
Explain marx circuit.
What is the difference between hot and cold loop testing?
mention hazard experienced during installation