Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kj
A motor will burn out because of the failure of the
insulation.
This can be because of heat from overload, high or low
voltage or not enough cooling. The insulation can also fail
because of moisture, age, dirt or salty environment.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how many types of motor can be used in washing machine
When will you multiply and devide with derating factors to the actual value while sizing the cable?
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
What is the disadvantage in proportional controller?
Why does the adjacent zone of protection overlap?
how to calculation increase capacitor,increase power factor for three phase.
what is the path of thunderlightening? once both a buffalo and a person were standing 5m apart but lightening hit and killed buffalo not person?
What is voltage ratio of a transformer?
How PADO software increase the efficiency of power plant?
Don't you have similar question banks related to Oral Certification Examination conducted by Mercantile Marine Departments / Directorate of Shipping, Ministry of Shipping for Electro Technical Officer?
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
What is the difference between security constraint unit commitment and security constraint optimal power flow?
How we select the vector group of 3phase power transformer?
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
How cmd is calculated in case of energy neters
