In any plant or substation main incommer voltage RY - 415
V,YB - 400 V, BR - 387 V(in commer feed from transformer 11
Kv /0.415 KV) why found voltage differance in each phase?
plant have not self power plant it is depend on outsource
grid
- 2 Answers
- 4373 Views
- I also Faced
- E-Mail Answers
Answer Posted / kj
First check the 11kv is correct. If the 11kv is different
on each phase the LT side will also be different.
If 11 kv is OK and the voltage is different on no load the
fault is in transformer as answer above.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
Pl. share your experience about industrial-electronics repair of machine tool.
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
How to minimize the eddy current losses?
Iin ESP why positive is grounded ? why not negative ?
State and define ohm’s law?
# 4 hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible my email id is sumit_lig189@yahoo.co.in
how could we calculate the no of outgoings from a 800 watt distribution board
what is gridrotor resistance starter
What will be the diameter of pipe between conservation tank and transformer
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
Explain Continuous and Discrete signals?
hi there i am highly enthusiastic about discussing electrical concepts , and hence i wud lyk to invit al do intrested to join me at gtalk and hav a dscussun of the concepts , ad me as a freind . my email id is rakesh.2k99@gmail.com
How to calculate the no of Ceiling fan (1200mm sweep) per unit area?
What is hipot test procedure?
