Interested to Buy Any Domain ? << Click Here >> for more details...
reason behind why the reverse power relay of incoming
machine was not acted even when no load was shifted on
incoming machine after synchronising the machines ?
- 2 Answers
- 4132 Views
- I also Faced
- E-Mail Answers
Answer Posted / kj
The reverse power relay operates when power is flowing into
the machine only.
If the machine is not taking any load it is not in a
reverse power situation. Therefore the relay will not
operate.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Pl. brief about break-down maintenance of machine tool.
What are Contactors? How they works and what its highest rating?
how can we calculate the ratio of caustic soda and water in lrs.
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
Hi My dear all Friends, There is a question regarding HVAC Engineering and widely used in Power Projects. Question- What is the diffrence Between REF, SEF and Differential Protection....???? Where REF - Restricted Earth Fault SEF - Senstive Earth Fault.
What is the theoretical reason for the size of a zig zag grounding transformer to be 1.732 times less than that of a wye-delta grounding transformer used for the same application?
why is control bus bi-directional?
Which contains in POLE ASSEMBLY of a 11KV Kirloskar-make SF6 (Model No-FP620A12)? Will u clarify with drawing?
Tell me all plants load factors i.e which plant operating on which load?
how can check the resistance of battery contact?
Write the force balance equation of m ideal mass element.
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
Can you explain about pole discrepancy scheme
plese send me the oces/dgfs sylabus and previous year question pattern of electrical engg.?
