Interested to Buy Any Domain ? << Click Here >> for more details...
If 110 volts ac is mixed up ith 12 volts dc what will be the
resultant voltage and what is the wave form?
- 1 Answers
- 3407 Views
- I also Faced
- E-Mail Answers
Answer Posted / kj
The wave form will still be the same.
It will be offset from the zero line by 12 volts. The
positive half cycle would then be to 122 volts and the
negative half cycle would be 98 volts at peak.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how to select correct size of power cable for inverter duty motor
orifice sizing how done, checking & selection
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
how much leakage current is allowed in MC61A L&T make relay?
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
what is distribution board?
what is ATS & RING MAIN UNIT in Distribution System?And its Function.
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
Why PT voltages are measured with respect to ground? What do u mean by voltage or current polarized.
along with technical test papers
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
What happens if i apply 500V to 440V rotary Switch ?
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
I am interested to know what does 15 KVA DG set actually means? If I dont know the DG rating, is it possible to identify KW by simply knowing the diesel consumption?
