Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference in design between Working Stress method
& Limit State Method ? Briefly Explain.
- 1 Answers
- 6322 Views
- I also Faced
- E-Mail Answers
Answer Posted / pintu dutta
Differences between Working stress method and Limit state method
Design of RCC Structures
The design of the components of the RCC structure can be done in the following two ways:
1.Working Stress Method
2.Limit State Method
Working Stress Method
*.The Stresses in an element is obtained from the working loads and compared with permissible stresses.
*.The method follows linear stress-strain behaviour of both the materials.
*.Modular ratio can be used to determine allowable stresses.
*.Material capabilities are under estimated tolarge extent. Factor of safety are used in working stress method.
*.The member is considered as working stress.
*.Ultimate load carrying capacity cannot be predicted accurately.
*.The main drawback of this method is that it results in an uneconomical section.
Limit State Method
*.The stresses are obtained from design loads and compared with design strength.
*.In this method, it follows linear strain relationship but not linear stress relationship (one of the major difference between the two methods of design).
*.The ultimate stresses of materials itself are used as allowable stresses.
*.The material capabilities are not under estimated as much as they are in working stress method. Partial safety factors are used in limit state method.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
Pls explain me about tension and compression in a flat slab
from one meter cube of stone masonry structure how much cubic meter of cement mortar we use as our estimation 25-30% is that correct for estimation of quantity of sand and cement(2:1) proportion of mortar
primary treatment of sewagw consist of removal of floating materials removal of sand & grit removal of organic materials all above
I need Bhel engineertrainy test papers in civil engineering please send to email id - hisandy66@gmail.com
1:4:8 pcc calculation 591 cu.ft
sir how can we find the cement and sand required for making 4" drop
A rock anchor 3 1/2” in diameter is placed in rock. The which has an allowable shear strength of 1200 psi. Determine the required anchorage length to safely carry a 80 ton load using a 2.0:1 F.S
how much area can be platered by a mason for exterior
why top layer of block work shoud be full size if any cut block adjustable than another layer?
i want texture painting pwd data
what r the precaution for high in atp tempareture,low in atp tempareture
How much for the BRC lapping in full yield and half yield < and which table to get it ?
Rate analysis of Vitrified tile in cement mortor 1:3
Define What is made from large rocks, which protects the base of cliffs?
Dear Frds, How can i calculate the Steel for RCC Slab, Please provide one Example also, so that i can understand very well. Ex: Area: 1320.0 Sft.(44' X 30') Span: 15'(Default). Column Size: 9"X15"(6 No.s 12mm Rods) Please Provide Calculation Details. Thankyou. Satish
