what is the rating of Insulation tester for measure 15 KW, 3
phase 415V 50 HZ induction motor?
- 2 Answers
- 5197 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / arul
Phase to Phase = 500 volt
Phase to Earth = 500 volt
IR Value should be greater then 200 Mega Ohm.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
what is effect of length of air gap on performance of dc motor and generator?
How can we calculate the motor frame sizes?
how can we say that stator magnetic field rotates with synchronous speed?can we derive?
12.5 tons a/c is their how much kva generator can recommend to the customer.
what is the advantages of having in-built acvvvf (without seperate inverter in the control panel)in the drive system of elevators?
Explain thin film resistors and wire-wound resistors
Explain the process of commutation in a dc machine.
Why different Pressure switch used in marine boiler water circulation system
WHY TERTIARY OF POWER TRANSFORMERS IS LOADED WITH EQUIPMENTS LIKE CT,PT,ISOLATOR AND CB
Which is the oldest hydropower plant in india?
What do you mean by a current transformer?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
new 90kw motor installed so how I purchased cable ,fuse,etc please give me technic for cable selected why always capacitor delta connection
