Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mugil
megering is the purpose of checking insulation.Checking any Damage,laekage in wire.
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
What is the difference between ff transmitter and non ff transmitter
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
how to control pid
How to Calibrate Ultrasonic Level Transmitter in field
What is the PLC configuration in Cement industry?
What is the purpose of bypass valve across AS valve.
Difference between dcs and plc including date processing and architecture.
What is difference of fanuc alpha series 16i and 18i controller.also what is differnce betn TC and MC controller
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
In which principles tx ,pressure gauge,Temp gauge,control valve works?
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
