Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pramod pandey
transformer rating in
kva because power
factor of transformer
is always depended on
other load.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why single phase to grd test in HV cable?why not 2 phase at a time?
What happen when neutral point connected to core balance current transformer? (Neutral point of an alternator of a 180KVA DG. Neutral point connected to CBCT means enter to the CBCT)
what is invertor supply and raw powersupply
what is the efficiency of thyristor
1sq mm dc powr cable can carry how much dc currnt
Why ground terminal is used in pot meter 10k ohms
In synchronization circuit what is the function of Interposing voltage transformer(IVT)and Reverse voltage transformer(RVT)
What are root loci?
Batteries. What is the difference between Lead and Nickel batteries ?
how to decide the panel size like MDB ,SMDB PANEL SIZES
How can we choose the rating of submersible motors
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
can any tell me why slope 40% and 80% is calculated in differential protection?
