Interested to Buy Any Domain ? << Click Here >> for more details...
waht is difference between pressure transmitter and
transuducer
- 4 Answers
- 7527 Views
- Gasco, I also Faced
- E-Mail Answers
Answer Posted / manoj
A trasducer is a electronic device,which converts non electrical quatity to electrical quantity(converts signal one form to another from)
pressure transmitter :A pressure transmitter is a devise to measure the mechanical pressure and convert in to electrical signal it may be 4~20mA or 0~10V
| Is This Answer Correct ? | 9 Yes | 6 No |
Post New Answer View All Answers
I need to know steps to Calibration Valve Guard......
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
How to Calibrate Vortex Flow transmitter in field
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
How to Calibrate Interface Level Troll in field
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
Why boiler chimney area oxyden sensor fixing?
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
Question on maha cement
what is a half wave, full wave, and bridge rectifer.
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
What is the difference bitween control net scaner and device net scaner
