Answer Posted / archana bharti
yes i want to find out iffco get solvedquestion papers
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
What is force balance principle? State some of its’ advantages.
how to calibrate 0- 150 psi presure gauge by dead weght tester
how to turbine speed measurement?
can you send remote seal interface level transmitter calculation steps for oil water saperator.
What is the difference between PLC and DDC?
What is the use of single seated valve?
can you provide me full detail about instrumentation in ONGC??
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
in differential pressure transmitter,min&max pressure range for hp&lp
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
key phaser where is use and work
How to calibration coriolis flow meter?
