Interested to Buy Any Domain ? << Click Here >> for more details...
In india the power supply is always in multiple of 11,
eg.220 V, 440 V...
what is the reason?
- 11 Answers
- 25546 Views
- BSES, Electrical, L&T, PSIT, I also Faced
- E-Mail Answers
Answer Posted / vinodmalik2009
There is no specific technical reason for the adoptation of
the voltage in multiple of 11, it is just to standardise
for manufacturing of different fittings, insulators or
other switchgears accordingly to limit the varieties.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
why only exciting current is shown not primary current in transformer???
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?
HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????
How to test IR testing & magnetic balance test
What is vaccum currcuit breaker.define with cause and where be use it device?
How to test REF relay testing for LV panel as per Kahramaa standard?
What is 100% protection of generator? Why 100% is not used but 95% is generally used?
when elecromagnatic waves are propogated in a wave guide?
what is the usage of microcontroller in the panel board?
What are IR values and what it should be for coil and for insulator
Compare jfet’s and mosfet’s.
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
What is minimum phase system?
