Interested to Buy Any Domain ? << Click Here >> for more details...
In winding design, the angle of chording (β) is nearly equal
to
A 45 degree B 60 degree
C 30 degree D 90 degree
- 1 Answers
- 7411 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / raghavendra
C 30 degrees
because by using 36
degrees we can
eliminate harmonics
but its difficult to
design for 36 degrees
hence in practical it
is designed for 30
degrees
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
How to minimize the eddy current losses?
Is electro plating what type of load whether resistive, inductive or capacitive loads
How to calculate ant test the burden of Current transformer
electrical ques
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
What will happen if the voltage in my house drops from 220V to any lower voltage?
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
What does the term power factor shows?
What is mean by hot and cold loop testing?
how can you calculate fault level ?
what is plunger and what's the use of it in motor alignment?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM
How can we increase fuel-power ratio of any DG set?
