How to calculate compressive strength of concrete?
- 15 Answers
- 279470 Views
- UPPCL, I also Faced
- E-Mail Answers
Answer Posted / rajeev kumar ranjan
depending upon quality of concrete,the nos of cube mold are decide.the cube set are stander size 150mm*150mm after pouring the cube mould.every cube mould is filled in required 3 layer&every layer 35 storks given.
the testing data such as:
1.name of the structure were the cube will be taken.
2.date of casting.
3.time of casting.
4.grade of concrete.
5.7 days result.
6.28 days result.
compressive strength= load in newton/area of cube mould(cm2)
| Is This Answer Correct ? | 51 Yes | 14 No |
Post New Answer View All Answers
cement required for construction of 400mm*200mm*200mm concrete solid blocks for 1sq.mtrs,how?
Gidc technical que paper
Special thing in designing a overhead reservoir ? which is different from an ordinary design
What is the cost difference between site mix and ready mix concrete per cubic meter
what do you know that m20,m25
What is an ortho mode?
which type of instrument included in plumbing work?name of instrument?
what is the use of steel rods of 16mm or 20mm used for 4.45mts for closing gutter.one mate consumes how many kgs with a gap of 6inches.
How should we design a brick column and footing?(note: no reiforcement to be provided) Can you tell me any reference book where i could possibly find this design? Plz help urgently
pls give me ans to ACT formula cube testing porpuse
How much percentage of brick bats allowed in CD-75 bricks
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
I measured pcc work as 15.34 m cube , the ratio is 1:5:10 ,want to know the cement, sand and metal used for pcc measured as 15.34 m cube at this ratio.
Design a reinforced concrete combined footing (rectangular) for two columns located 3.60 metres apart. The overall sizes of the columns are 40cm x 40cm and 69cm x 60cm and the loads on them are 1000 kn and 1500 kn respectively. The space available for the width of the footing is restricted to 180cm. The S.B.C. of the soil is 280 kn/mm2 use M15 concrete.
What are the problems one might face while having a Cantilever balcony?
