what is a minimum strength recommented for aerocon blocks?
- 2 Answers
- 4314 Views
- I also Faced
- E-Mail Answers
Answer Posted / pranav panchal
Minimum 35 kg/cm2
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is anchorage length,lap length and (dont remember the last one)
what is called the inverd level of mabhole chamber?
which type of instrument included in plumbing work?name of instrument?
in plate load test what is the thickness of plate 20mm 5mm 50mm none
flow of fluid takes place viscosity compressibilityu surface tension deformation under shear force
What is rate of concrete surface rendering work per sqm
What is the significance of cost estimate knowledge for an architect?
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
how to calculate detail quantity of bricks and mortar for 500 cu.ft masonry work. consider wall thickness 9 inches
How do we calculate the power of centrifugal pump?
What is the zero value in quantity surveying
how to identify np3 pipe and np4 pipe
What are the different methods for drawing an arc?
what are the changes in concrete pour height as per IS 456, 2009?
01. a. Diagram of a slump cone…………… 1 b. Size of Slump Cone…………… 1 c. Volume of a slump cone by av. Dia method…………… 1 d. Volume of a slump cone by av. area method…………… 1 e. Volume of a slump cone by frustrum method …………… 1 f. Angles of slump cone …………… 1 g. Slump measured by slump cone due to…………… 1 h. Slump does not measured by cylinder / cube due to …………… 1 i) ii) i. Slump cone is to be filled in……………………..Layers.
