Interested to Buy Any Domain ? << Click Here >> for more details...
How can you start-up the 40w tube lite with 230v AC/DC
without using any choke/Coil?
- 2 Answers
- 5102 Views
- I also Faced
- E-Mail Answers
Answer Posted / shailendra
we can use 200w bulb insted of choke. or
we can use about to one bucket water. in
the place of choke connect two electrode
of battery cell and drop both electrode
in water bucket.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Why r u using pf panel. what the uses
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
how to calculate current carring capacity of cable and cable selection? 1) copper flexible cable 2) copper armoured cable 3) Aluminium cable
what will happen if the prime mover on the field excitation of the on-coming generator fails?Explain.
Why the field rheostat is adjusted such that the voltmeter reads 380V
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
Can we Co-ordinate relay in Load Break switch?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
what is the purpose of high speed earth switch in gas insulated substat
how to determine the inrush current of a transformer
Why we use circular(Stepped) cross section in transformer core?
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
why Lightening Arrester Probe sharp at Top of telecom tower.
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
