Interested to Buy Any Domain ? << Click Here >> for more details...
which tie is used in binding of steel double tie or single
ti?
- 1 Answers
- 4801 Views
- I also Faced
- E-Mail Answers
Answer Posted / ratheesh
Double binding is always good. if u want to reduce the
construction cost you can use single bind, but above 12 mm
rods should be done with double binding.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How much cement and sand are required for 1 square feet of plaster at a thickness of 15 mm at a ratio of 1:4?
how to estimate man power for estimating the time required for completion of a project in terms of carpenters,barbenders,masons for block work ,masons for plasteing ,unskilled labour, painters, tiles masons,plumbers and electricians for medium and high rise constructions and independent villa projects.
WHAT DLC DESIGN IN CONSTRUCTION
Can anybody help by describing each and every step in short, used while giving a building layout by total station? Regards
Please let me know about answer for my Question as "What is the maximum wastage allowable of HYSD Steel in any Bridge project as per Code and Code reference also ?
How to calculate the load of partion in flat slab if we use brick?
How much cement is require in one sqft area in a G+3 residential construction.
What is Grid floor and mention its advantages ?
At what point does a circle start losing area when being flattened?
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
why do we not deduct volume of steel to find actual volume of concrete in practical???
What are the different approaches in designing the floors of the service reservoirs?
HOW TO CLACULATE CEMENT AND SAND CONSUMPTION FOR THE STAIRCASE KOTA FLOORING IN THE RATIO OF 1:4 50 MM THICKNESS
Describe the sections included in a typical bill of quantities
What is unit weight of roadway layer.. 1.bitumen 2.sand 3.soil 4.concrete 5. aggregate give me some reference for this answers
