why AC cannot to be stored and DC cannot be transmitted?
- 11 Answers
- 35787 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / daniel joel
AC cant be stored because as
it changes at every instant of
time but we can charge it
upto half cycle and another it
discharges. Actually dc is not
transmitted because various
energy sources develop AC
which is of high value and
since our electronic devices
work for the constant value
we convert it to a small value
by means of rectifiers,filters
and regulators. Another
reason for not transmitting
dc is we cant step up or step
down it by means of
transformer.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
How to calculate the phase to phase clearness of HT /// LT bus bar?????
what is a bus post insulator? explain its application in a substation.
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
I want to know the 'Test voltage' for Tandelta testing of 3.3 / 6.6 / 11 KV Motors. Please explain
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
Why do we use copper cable for HT Supply and why not Aluminium?
in non technical way how can u define POWER FACTOR??
electrical ques
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
