Interested to Buy Any Domain ? << Click Here >> for more details...
Is an analogue only transmitter as accurate as a smart
transmitter?
- 2 Answers
- 4994 Views
- SCA, I also Faced
- E-Mail Answers
Answer Posted / rezvanian
"smart" means that you have a SIMULTANEOUS analogue signal
and digital communication. So HART is "smart" because it
has 4-20 mA and the Bell 202 modulated communication at the
same time. it can also perform diagnosis. I believe that
its not a communication protocol. Smart transmitters can
use any protocol for communication …
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
how to calibrate and troubleshooting of leveltroll?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
What is the main difference between Cavitation and Flashing?
What is instrumentation technologists and mechanics?
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
What is frequency factor in massflow meter? When using frequency output?
whatis range of marcury filled tempereture gague
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
what are the selections available in configuring a burnout protection of a controller? thanks
How many interlocks at turbine? Plz explain briefly
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
why we are using drum level control valve air to close?
What is the principle of capacitance type level transmitter?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
