Answer Posted / sheikh
Different kinds of over current relay are available.
on HT side over current relay is a part of protective relays.
and LT side over current relay are using in motor starter,
ACB. There are 2 type of over current relays used in motor
circuit one is thermal over load relay second one is EOCR
electronic over current relay etc.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
explain wiring system
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
1- XC and the RC time constant are both measures of the reaction of C to a change in ____? 2-The power factor is a numerical ratio with a value between 0 and 1 equal to the ______________ of the phase angle. 3-When V and I are out of phase because of reactance, the product of V times I is called ______________ power 4-For _____________ inductors, the branch currents can be added algebraically. 5- The ______________ power in watts can be calculated as I^2R 6-Calculate XL with L = 30mH and f = 1kHz ( I have Xl=2piFL 2*3.141592653*1kHz*30mH =188 ohms Please check) 7-A parallel RL circuit has the values, R = 5kohms, XL = 5kohms. A voltage source of Vt = 10Vrms is connected in parallel to R and L. Determine the total current, It delivered by the voltage source Vt. 8-A series RC circuit has R = 1Mohm and C = 1microF. How long would it take for the capacitor to fully discharge if it is initially fully charged? 9-A circuit has real power = 300W and an apparent power of 500VA. Determine the power factor and phase angle. 10-The time constant for an LR series circuit is T = 0.1s and R = 10ohms. Calculate the inductance L.
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
A d.c. Shunt motor is found suitable to drive fans because they require?
What is dielectric loss?
Iwould like to know barc interview questions
What determines the thickness of the lamination or stamping?
What is Instantaneous Earth fault relay,how will work
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
Why auxiliary transformers are not connected in parallel in primary stations?
why Lightening Arrester Probe sharp at Top of telecom tower.
why transmission is only 3 phase and not 2 or 4 or poly phases
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
