what will happen if dc motor given ac supply
- 11 Answers
- 37701 Views
- Mahaveer, I also Faced
- E-Mail Answers
Answer Posted / jishnu
it depends on the winding connection with the armature
1. connected in series
the motor works normally as same
as the DC series motor
2.connected in parallel
the motor will not rotate because the torque
produced in the rotor due to ac is equal and opposite in
magnitude and direction hence resultant torque produced in
rotor is zero
| Is This Answer Correct ? | 27 Yes | 5 No |
Post New Answer View All Answers
What is the Nyquist criterion regarding control systems?
a simple c++ program to calculate simple interst with its data members as private
Why we are going for converter transformers for DC drives application instead of distribution transformer?
How to calculat the ratio of HT\LT in energy meter
what is subtransient , transient and steady stateac components
What is the difference between a Root Locus plot and a Bode plot?
How could I get a certificate of competency as Electrical Supervisor? I have completed By BTech in Electrical this year(2012) for VJTI Mumbai Maharashtra. Is it compulsory to be produced while joining?
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
If the Brush of DC motor is shifted by 90 deg, then what happens to voltage and torque? Both voltage and torque are zero. how to justify the answer?
What is Control & Relay Panel? And Remote Control Center?
What is power factor why we should maintain the power factor unless what will happen
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
how to select the double earth conductor if 21A full load?
