wat is the advantage of increse in frequency?how the
powersupply range decreses as the frequency increses?like
in america,it uses 110 ac and 60 hz?
- 4 Answers
- 5599 Views
- I also Faced
- E-Mail Answers
Answer Posted / krishna sai
with the increase in the frequency by keeping the kva rating of the machine constant then the size of the machine can be reduced.
on the other hand during the design stage if the frequency is increased then the KVA rating of the machine will be increased as KVA proportional to EI where E(induced voltage) is proportional to f. Power supply voltage range must be decreased along with the increase in frequency so that the machine will be safe without getting into saturation
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
is there any phase difference occurs while primary and secondary side mutual induction occurs?
Hello everyone, somebody knows what is a "surplice power" ? The hole phrase is: "This rating is appropriate for a generator set paralleled with an infinite bus e.g. a national electrical supply network or grid where the generator set is run at 100% load, 24 hours a day, 365 days a year and any surplice power is exported into the grid" Thanks in advance.
In parallel operation time both NGR’s close or not close if both close what will happen
why impudance relay used for medium transmission power system? why not others?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
Why is a plain induction motor unsuitable for wide speed control?
How much dc volt applied in cathodic protection system?
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
The principle of switching circuits for different types of batteries in application of storage systems
What is 11 N1 and 12 N2 in single phase Transformer ?
In Indian Household, generally we receive 220V AC single phase supply. But AC has 2 phases, +ve & -ve. So in +ve half cycle current is flowing...so what happens in the -ve half cycle?? Please illustrate.
what are the 4 rules to start the motor?
pls,send the previous year written test questions.
Why air circuit breaker off due to power failure?
In EB metering we face problem kva jump even in no load condition.can any one help to control this
