Interested to Buy Any Domain ? << Click Here >> for more details...
What are the condition for parallel operation of transformers?
- 2 Answers
- 5611 Views
- Alfanar, I also Faced
- E-Mail Answers
Answer Posted / joseph mbale
on polarity should equal.
same phases (in phase)
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
If more than rated DC voltage appears across trip coil of the breaker, what will happen? e.g. in 110V DC circuit system, if voltage across battery terminal showing 121 V
How to Calculate The sag of OPGW in Transmission Line???
In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?
HOW TO CALCULATE ELECTRICAL, MECHANICAL,& OVERALL EFICIENCY OF GAS ENGINE POWER PLANT
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
What is gross error?
How to select the cable and voltage drop in circuit?
what is consequences of neutral and earth connect?
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
How to calculate Voltage regulation of 22 KV Over head Line.
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
