Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / anand kumar jha
an scr is controlled by gate but in diode it can not be
controlled.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is meant by tranformer impedance?
define hysteresis loss, eddy current loss and windage loss
WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.
state the working principle of incondenscent tube?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
what is the operating time for LBB and how does the LBB relay realise whether cb is opened or not?
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
what is doid
distribution is maximum done by a)radial b)network c) parallel d)b & c
Difference between RCCB, RCBO and ELMCB.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is force on parallel conductors ?
What are the components of feedback control system?
why should the primary of transformer be connected in delta in a heat run test?
kindly send me 11KV MV motor differential protection procedure by primary injection method.
