Answer Posted / selvakumar

The resistance of material will change per degree of temperature change,RTD is a positive temperature Co-efficient i.e resistance value will increase whenever temperature increases.
At 0 degree celsius Pt100 have 100 ohm,resistance will increase by increasing temperature .
To calculate R-R0/R=alpha*(T-T0)

hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.

2232

---

can any one explain in which term we are flow flow is it volumetric r is it mass? and y

1993

---

For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.

1980

---

what are procedure of sox-nox calibration

3039

---

while i check zero check for dp flow transmitter some fluctuating came (0 to 458 kg/h) what is the reason?

1979

---

Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?

2218

---

is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?

2283

---

where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia

9995

---

Questions on flow meters,few questions on HART protocol,

2063

---

what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?

2219

---

i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?

2376

---

Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows

2156

---

what is cold loop? difference between hot and cold loop?

2306

---

Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com

2346

---

If fire would be inside the plant which fire detector is to detected the fire.

1662

---