why we are using the ac supply in domestic purpose, why
don't use dc supply.
- 5 Answers
- 6511 Views
- I also Faced
- E-Mail Answers
Answer Posted / sai
the dc suply is
a continuous
flow of curent
so it is
harmful.so ac
suply has
fluctuations in
it so it is less
harmful. So we
use ac but we
need dc suply
for al apliances
so we use
rectfiers.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
describe the phenomena of vacuum interruption in C.B
Starting Time of LT & HT Motor
which types of relay used in acb and vcb?
We have 110Vac ,10A ac supply which is converted into 110VDC & How much DC current? which factor is reqired for dc current calulation?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
How to Prepare preventive maintenance shedule of machine tool.
how much flux density of CRNO core
Explain what is electric traction? Explain few advantages of electric traction system?
why do we not use equivalent voltage source in negative sequence equivalent ckt.
In what condition the HT fuse breakes?
What do you mean by dependent and independent voltage sources?
What happens if the series current double?
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
