why substation are rated like 11KV or 33KV?
- 3 Answers
- 10351 Views
- TNEB Tamil Nadu Electricity Board, I also Faced
- E-Mail Answers
Answer Posted / selvin
the protection devices and loads are operating level based
design purpose
| Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
Why it is possible to use PWM with a STATCOM and not with a conventional TCR based SVC
3 phase induction motor connection star or delta while using ac drive motor is .75 to 5.5 kw
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
What is the method for testing the differential protection stabilty in generator? When the time of starting What will happen if differentail protection connection wrong means?
According to conduit size which size wiring & how many wires can we provide wires in conduit & how can we select conduit size accordingly?
1. for eg, capacitor is used for many purposes(it act as filter, oscillator, bypass capacitor, memory storage etc...) 2. Please tell me some example circuits for different uses of capacitor( whenever and whereever and however we used capacitor as a filter, oscillator tuning etc..) 3. similarly for inductor and resistors(it act as what?) and when and how we want to act as like that?, and how we can used these components depends upon our requirments with example circuits and explanation? design to act as these components depends
What are the material used for inductance coil?
why induction motors are rated at 0.8 power factor.
can we use engine degreaser for electrical motors?
What is dielectric loss?
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
Differnce between negative Pahse SequenceFunction and unbalance Function?
