Answer Posted / irfanullah

Basically we know that current is divided in parallel network .in order to control the current ratings for both field and armature in such cases we are using starter .

what is the Connected Load (kW) or Contract Demand (kVA)of mahindra nasik plant??

9492

---

How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?

2895

---

Formulae for calculating the transmission line losses for different voltage levels

2177

---

List advantges of active filter over passive filter?

1091

---

Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???

1972

---

Initially, when the input is not equal to the output — what type of response is this?

1061

---

What are the major reasons for balancing hydro-thermal mix?

1137

---

how can we change the phase angle b/w two phase?

5176

---

List out the the types of Mounting Light fixture?

1609

---

If the feeder rating is 7.5 kw or 10 HP star-delta feeder, MCCB is taken as 63 a, contactors-32 a, how much will be the OLR rating or which range OLR should be considered when we concern about type-2 coordination?

2311

---

How to select circuit breakers rating eg. if i select a circuit breakers of capacity 40 amps DC with operating voltage 28 volts and if i what to use same circuit breakers for 300 Volts DC application what is the current rating of this circuit breakers.

1729

---

How would your past experience translate into success in this job?

6889

---

what is difference between elr and R eartl realy.

2633

---

What is Meter MF if External CT Ratio is 150/1 , PT Ratio is 132/110 Meter CT Ratio is 200/1 & Meter PT Ratio is 110/1

1882

---

wat is meant by PX class in ct?

2043

---