Answer Posted / rajesh.kon
Control cable are used for to control the equipment like
motor, VFD, MOV from the control room.
it's normally 3 to 4 core cables.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why flow/pressure transmitter before control valve?
WHAT IS MEANT BY PROJECT MANAGEMENT STRATEGIES IN INSTRUMENTATION?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
Calibration procedure for electro magnetic flow meter
is motorized valve closed when power shutoff?
Explain signal isolator
how the arrangement of equipments done in control room
Explain pH, Conductivity.
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
What is standard procedure of manual mapping in Radar type level transmitter?
Explain an adaptive / self-tuning controller’s major draw card.
In turbine, what does term CDP, NI, NH, HSSOC, means
principle of dead weight tester ?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
