Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / chetan
Rtd range is -200 to 850
temp
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
What is sensitivity in vibration probes..?
why we are using magnet for calibration of gas detector?
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
what is temperature compensation?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
State some of balance principle’ advantages?
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
Calibration procedure for water rotameters
Explain the burnout feature.
What is stripper & spilitter ? Diffrence in this.?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
describe flow nozzel principle?
