Why all voltage levels are the multiples of 11KV?
- 10 Answers
- 50931 Views
- KSEB, I also Faced
- E-Mail Answers
Answer Posted / soumya ranjan mania
Dear friends,for your kind information form factor of full
sine wave is infinite,but it is 1.11 for halfwave,how
halfwave formfactor is related to our topic,as we need
fullsine wave so form factor has no related to generation of
voltage multiple of 11,so only answer is only the historical
perspective ie In early days when technology has not
advanced this much,the transmission lines consumes around
10% of the totalpower transferred. Normally loads are
designed as multiples of 10 or 100 KW. So the generation
done for required load power + transmission loss. ie 11KW,
110KW etc. So generated voltage also was designed as
multiples of 11.
| Is This Answer Correct ? | 14 Yes | 11 No |
Post New Answer View All Answers
132/66kv sub-station procation ?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
how to commissioning the genset with amf panel?
What is meant by coupling capacitor?
How to calculate wire length,size & current? ( related to control panel)
What is power distribution criteria for converting single phase unbalanced residential load to 3 phase star connected balance system. Does total KW converted to 3 Phase. Means Divided by root 3.
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
which type of stability limit is higher,steady state or transient? why?
What is the bundle conductor?
how to select the isolation tranformer for siemens 802dsl cnotroller
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
Please brief me about number of pole in alternator.In single phase alternator coils are connected in star or series. How to calculate frequency for the same.
what is the difference between 2 way and 4 pole selector switch???
How to calculate per unit impedance of transformer?
