why we are connecting the alternator to a steam turbine of
higher RPM then the rated RPM of alternator?
For example:( connecting 1500 rpm alternator to 7600 rpm
steam turbine). we can directly connect the same rpm
turbine to alternator know??? is there any special reason ???
Answer Posted / k.prakashchandra
Whenever there is sudden 'load throw off' ,the rpm of the
turbine increases considerably ,it may even attain run away
speed which may be 5 times the normal(working) rpm
Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Can you explain about pole discrepancy scheme
I want to know how to calculate the size of electricity cable in building?
from which subjects most of the technical que will b asked for hpcl(electrical).pls help me
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
which pump used in STP
why r we using shell transformer for low voltage
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
I completed iti in2004 I was worked in A grade contractor can I get c licence
draw vector diagram and +ve,zero sequence diagram of symmetrical three phase fault.
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?
What will happen if i used 11KV earth ht kit to 11 KV / 11 KV cable termination?
what is droop control?
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me