If single phase voltage level is 230V than why three phase
voltage level is not 660V ?, but it is only 440V.
Answer Posted / jawad 923218471617
that is where frequency does matter, because with frequency one of the three phase become neutral after a timeperiod. so for that reason at a moment two phases are showing 440v in pakistan).
Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
how we findout a ignater is faulty or not?
When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?
bsnl tta exam question
What is current & voltage ? Voltage perform at any load without current or not?
what are the main faults that occur in stabilizers? How they corrected and resolved ? Types of stabilizers ?
Load break swicth maintenance procedure.
When can we take Neutral as common neutral link?
how to select the isolation tranformer for siemens 802dsl cnotroller
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
when ac current flows thru d coil of a contactr,it energizes,magnetic field attracts d contact of the coil...nw wont dt ac current in d contct induce current back on to d coil thru mutual inductance leading to high currnt in d coil
how you taken aotitude test
thyristor controlled APFC panel design parameter?
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.