Interested to Buy Any Domain ? << Click Here >> for more details...
IN A SMALL D.C GENERATOR, IF WE REPLACE THE LAMINATED
CORE ARMATURE WITH A WOODEN BLOCK OF SAME SIZE & SHAPE
AND WIND WIRES WOUND ON THE SLOTS OF WOODEN ARMATURE AND
CONNECTED TO THE COMMUTATOR.COMMUTATOR IS FITTED WITH BRUSH
TO RECEIVE INDUCED E.M.F.WHETHER E.M.F GENERATED OR NOT?
- 3 Answers
- 4780 Views
- I also Faced
- E-Mail Answers
Answer Posted / rupesh kumar choudhary
It will work but amount of E.M.F. induced will very less
and it can not be practicaly usable for operating any
device.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the minimum underground tank size capacity considered for firefighting purpose?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
bitumar
How many double suspension hardware fittings are required on a double circuit transmission tower?
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
why to use freewheeling diode ( diode in revers bias mode) across dc coil
why tertiary winding is used in transformer with diagram?
What is proportional controller?
how to calculate slip ring induction motor stator and rotor currents??
operation of protection relay watchdog contact?
i wasted one year for the job after completed my btech what can i say about 1year time in interview
What is difference and reason b/w -48V BTS system and 24 V BTS system. Plzzzzzzzzz tel me.
Can we use both Electrical & mechanical interlock between tow breakers? if yes how, please explain
What is stacking factor? What is its approximate value?
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
