What is the difference between Earthing and Neutral?
- 13 Answers
- 24242 Views
- I also Faced
- E-Mail Answers
Answer Posted / d.k.sahu
Earthing is used for safety of equipment and human life.
its resistance should be very low.
But neutral is used for complete path of 1ph ckt and also
neutralise the unbalanced load.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
it is possible to measurement of tension of slipring induction motor(SRIM)carbon brushes, any maesuring instruments are available in the markets.
In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
why the carbon brushes are broken in srim while the motor runningtime
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
features of hbc fuses
DESCRIBEPNEUMATIC SYSTM OF ASH HANDLING PLANT
what is Fan Control Cubicle
Why we are using Isolation Power Transformer inplace of commercial power transformer? What's the difference between them?
What is meant by sag?
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
State thevenin’s theorem?
TO CALCULATE THE RESISTANCE OF GRR OF HT MOTOR 400KW WHEREAS STATOR VOLTAGE 6.6KV AND ROTOR VOLTAGE 705V AND ROTOR CURRENT IS 346A.
what is the maintaining Cf in UPS.
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
