what is plc?
Post New Answer View All Answers
What are the application of bernoulli’s theorem?
what is the procedure of belt scale calibration?
How to calculate P,I&D value in PID controller ?
on interface level transmitter model(RTG3302-EMERSON) What is threshold valve how can we select correct threshold value T1,T2,T3,T4 When interface water & hydro carbon
what is the imbustion control loop
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
Explain types of valves?
What is the minimum rating availalbe for weld neck orifice in market?
how many types of viberation transmitter and how to calibrate and where use of vibration transmitter
why orfice is not used for main steam flow calculation
can you send remote seal interface level transmitter calculation steps for oil water saperator.
describe flow nozzel principle?