Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference about HART, and 4-20mA signal?
- 8 Answers
- 43209 Views
- I also Faced
- E-Mail Answers
Answer Posted / mujahid/dinesh
HART compatible transmitter transmits digiatl signal super-
imposed on analog 4-20 mA signal and gives many useful
infoarmation about the transmitter and process parameter
other than output.
this enables a two way field communication to take place,
making it possible for additional info rather than the
process variable only.
Hart protocol is a Master/Slave protocol, the HART protocol
can be used in different modes like point to point or
multidrop for communicating info from/to smart fiel device
and the controller, the field device and the controller
should be HART enabled.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
selection of the zener barrier for the hazardeous area zone 0
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
How is flow measured in square root?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
Explain the combusion chamber
what is function of switch, and how is it work, explain with difination
What is difference between radial vibration and axial vibration explain in detail .
what are the diff. in servo and regulatory control?
components of control circuit belongs to control valve
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
How to Calibrate Ultrasonic Level Transmitter in field
what is the reset offset and control system in instrumentation
What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?
