In Star type and Delta type Motors, If one phase will
miss/Break then which phase winding will burn and why?
Answer Posted / engr. kashif
If ur motor is well protected then thermal tripping will prevent any winding burning.
If however no safety exists then one of the two windings
whose phase is ok will burn out due to excessive current and
heating.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Why L.T.Cable voltage rating is 1.1kV,where as system voltage is 0.415kV?
PLS MENTION QUESTIONS ASKED IN IOCL INTERVIEW FOR ELECTRICAL EGG??
Operation of isolators.
What are the different types of controllers?
Dear sir, How to calculate 3.5 core pvc aluminium armoured cable meter wise carrying amps rating.Please give the solution with a good example.
Why CBCT rating is 50/1A
can anyone send me some sample question regarding power grid corp
What is the difference between multimeter
why single phase to grd test in HV cable?why not 2 phase at a time?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
What are the advantages of hydropower?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
What happen when neutral point connected to core balance current transformer? (Neutral point of an alternator of a 180KVA DG. Neutral point connected to CBCT means enter to the CBCT)
what is the principle of operation of tungstun bulb ??
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.