Interested to Buy Any Domain ? << Click Here >> for more details...
i/p converter always for supply pessure from 3~15 psi
only !! And from where this converter bleed the air.
- 2 Answers
- 5296 Views
- I also Faced
- E-Mail Answers
Answer Posted / vinoth
I/P converter gets the bleed off air from the Air compressor
unit.
From air compressor unit, air will go to a regulator
from where the Pneumatic air is supplied to the I/P converters.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,
In apron feeder how TPH is calculated?
What is the diffrence between digital signal processing and discrete signal processing?
in valve is constructed as per SME B 16.34, then which standard is used for fire testing of valve?.
in differential pressure transmitter,min&max pressure range for hp&lp
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
What are the maximum packet size of: a) HART b) Profibus DP c)Profibus PA d) DeviceNet e) Foundation Fieldbus
Specify for Cables - Flame Retardant and Fire Resistant?
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
Draw a P& ID showing – orifice flange, plate, dp transmitter, isolation & bypass valves and tubing.
We are using Rosemount 5400 series Radar Level Transmitters in all types of Sump Applications having oily water hdrocarbon petrochemical nature. What we are facing the problem frequently is that always getting reading frezzed at some value. If we do power recycling , sometimes it is working . then making same freezing problem. If anybody faced before such type of problem and also having solution , Please give the answer.
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
