Why capacitor bank is not neccessery to switch on,pls answ
me with formula
- 2 Answers
- 3952 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
normally the capacitors are switched on to bring the power factor nearer to unity i.e 1.
if load(kw)is almost equal to generator capacity (kva)or if power factor is between 0.9 to 1 we wont Switch on the capacitors.
capacitors are rated in kvar(kilo volt amp reactive )
apparent power=kvar=sqrt(3)*V*I*sin phi
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what are the applications of PLC?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is kvarh? Please define it With calculation General motors ?
which type of cabel
Define what is difference between fuse and breaker?
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
Give accurate definitions for these electric terms: Inductor Inductance Inductive Induction Reactance Reactive Esam Baraka ٢١ ساعة
What is the basic principle of operation of alternators/dc generators?
State thevenin’s theorem?
explain the what is a drive ? 0 4 which type motor r use in the celling fan..... PCB plannet 2 13 If stator & rotor of a 3-phase induction motor have different no. of poles, will the motor run or not?? types of drives Why dc supply is used for closing and tripping coil of ht breakers. What happen if we use only ups ac supply only. ACC 1 41 how the 3phase induction motor is running in 2phase supply with help of capacitor? 1 33 what is the actual difference betwen constructional details and constructional features? 1 20 how does commutator convert a.c to d.c?
Can you explain about TEE protection scheme?
Swg formulae
What is an iron loss or core loss pi?
what is two point starter?
after how many spot we must chang secondry cable in portable spot welding gun?
